dimming plus
Geplaatst: di 18 dec 2018, 08:50
Dear,
I'm programming the Gira Homeserver 4 with the QC and a Gira Dali gateway.
For the MMI (interface) I'm using in the QC the "dimmer plus" function template (ID 1-102) with Operation set in "Toggling mode"
The behaviour I'm expecting is
Off -> On: Brightness goes to 100%
On -> Off: Brightness goes to 0%
Brightness set >= 1: On
Brightness set to 0: Off
I set the Dali Gateway as follows:
with feedback set as:
feedback - switching feedback - dimming
(zelfde als voor switching maar kan maar 3 beeldjes opladen)
The behaviour is sometimes going like this:
dimming to 1% through the + button: On BUT then it jumps to 100%
I can understand this behaviour as when I set 1% the switching feedback is going through the switching GA and sets it to ON and sets a 100% dimming whenever the ON is latest on the bus. When the ON is first the 1% comes after and keeps it right.
So how can you properly achieve this result?
Many thanks.
I'm programming the Gira Homeserver 4 with the QC and a Gira Dali gateway.
For the MMI (interface) I'm using in the QC the "dimmer plus" function template (ID 1-102) with Operation set in "Toggling mode"
The behaviour I'm expecting is
Off -> On: Brightness goes to 100%
On -> Off: Brightness goes to 0%
Brightness set >= 1: On
Brightness set to 0: Off
I set the Dali Gateway as follows:
with feedback set as:
feedback - switching feedback - dimming
(zelfde als voor switching maar kan maar 3 beeldjes opladen)
The behaviour is sometimes going like this:
dimming to 1% through the + button: On BUT then it jumps to 100%
I can understand this behaviour as when I set 1% the switching feedback is going through the switching GA and sets it to ON and sets a 100% dimming whenever the ON is latest on the bus. When the ON is first the 1% comes after and keeps it right.
So how can you properly achieve this result?
Many thanks.